Cleaning The Print Head - TOSHIBA TEC Corporation SL-9000 Series Owner's Manual

17. CLEANING THE PRINT HEAD

17. CLEANING THE PRINT HEAD
Since there is a cutter at the paper outlet, be careful not to injure your fingers when
cleaning the print head and cutter.
If the print head is dirty, printing will not be clear. The print head should be cleaned with a print head
cleaner everyday before use, according to the following procedure:
1.
2.
Print Head Cleaner
3.
NOTE: Be careful not to damage the print head when cleaning.
4.
After removing the label cutter, reattach it using the following procedure.
1.
2.
3.
Screw (FL-3x6)
Clearance
0.5~0.8 mm
Peel-off Plate
NOTE: If the cutter is scratching labels during printing, increase the clearance between the cutter
Get user manuals: See SafeManuals.com
Open the label cover and remove the label cassette. (See page 9-1)
Clean the print head element with the print head cleaner.
Print Head
Clean the print head element with the print head cleaner.
If any label paste is found on the cutter, wipe off the paste with alcohol.
Install an unloaded label cassette on the scale.
Install the label cutter, aligning the cutter notches with the screw holes.
Secure the cutter with the screw (FL-3x6) so the bottom of the cutter is 0.5~0.8 mm above
the peel-off plate.
Label Cutter
and peel-off plate.
WARNING!
Screw (FL-3x6)
17-1
EM1-31064
17. CLEANING THE PRINT HEAD
Element
Head Holder
Label Cutter