Snmp Alerts System - Temperature, Authentication, Configuration - Opengear OM1200 User Manual

SNMP Alerts System - Temperature, Authentication,
Configuration
Temperature
CONFIGURE > SNMP Alerts > System > System Temperature
It is essential to ensure that the system is operating within its design temperature
as premature aging of the component can occur if the device is excessively hot dur-
ing operation. This can lead to component failure and ultimately result in RMA.
When temperature SNMP alerts are enabled (Alerting), network operators are imme-
diately notified (subject to network connectivity and latency) should the PSU begin
operating outside user-defined temperature tolerances.
System generated SNMP Alerts send SNMP traps to a remote SNMP manager
which alerts the user of temperature events.
Tip: The OM device can send network, power and system events to the remote
SNMP manager.
Configure SNMP System Temperature Alerts
Configure > SNMP Alerts > System > System Temperature
The System Temperature Range alert reports the system temperature (measured at
System Temperature 1 and System Temperature 2 sensors) and sends an alert
when the system temperature leaves or enters the user-configured temperature
range.
CONFIGURE MENU 55