Opengear ACM5004-LR Quick Start Manual

Thank you for purchasing the ACM5004-LR Remote Site Manager (referred to herein as
ACM5004-LR). This Quick Start walks you through installation, configuration & local
operation. More details are available in the User Manual , which can be downloaded from:
http://opengear.com/documentation
Step 1 Check k it c ontents
Step 2 Connect t he h ardware
Attach rubber feet to base and/or attach the desired mounting tab
Ø
Screw the antennas on to the MAIN and AUX connectors
Ø
Note:
product family. As well as 3G, it supports 4G LTE – however it does not support GPS.
Your carrier will provide a standard size Mini-SIM (2FF) card for activating your
Ø
data plan – unscrew the SIM card access panel and insert the SIM card with
contacts facing upward and notch to the RHS (the SIM card will lock into place,
you may wish to use a pencil or tip of the antenna to fully seat the SIM card),
then replace the SIM card access panel
Connect the Ethernet LAN USB 1 port to your primary network
Ø
Connect your serial devices to the four SERIAL ports, and/or connect a USB
Ø
device to the USB port
Plug in the green screw terminal block and attach external sensors and DIO
Ø
Note:
Apply power
Ø
Note:
+/- 36V DC to 72V DC), plug it into the PWR socket on the ACM5000
ACM5004-­‐LR Q uick S tart ( 520083-­‐Rev 1 .0)
The ACM5004-LR is a functional upgrade replacement for the ACM5004-G
For the -I model, refer to the Quick Start Addendum .
If you ordered the optional external DC-DC power converter (input voltage
Quick Start Guide
ACM5004-LR appliance & mounting tab; green
terminal block; two antennas, cable & mounting tab;
two UTP cables; two DB9F-RJ45 adapter (319015, to
DTE & 319014, to DCE); DB9M-RJ45 adapter
rd
(319016, to 3 party console cable); four rubber
feet; 12VDC power pack; Quick Start Guide.
ACM5004-­‐LR
.
Page 1