What To Do When Encountering Problems In The Basic Shooting Operations - Panasonic AW-HE20KP Operating Instruction

What to do when Encountering Problems in the Basic
Shooting Operations
If the trouble is not resolved by taking the action suggested below, refer to "Troubleshooting" section.
When performing the operations using the wireless remote control
The unit does not move.

- Press the [CAMERA 1], [CAMERA 2], [CAMERA 3] or [CAMERA 4] button to select the unit which is to be
operated.
- If only one unit is being used, it is normally selected using the [CAMERA 1] button.
- Check that the Wireless ID has been set correctly.
- If the unit's status display lamp is off or lights up orange, it means that the unit's power is not on.
- Refer to "Power on the Camera Unit" section.
- If the unit's status display lamp does not blink even when the wireless remote control is operated near the unit's
wireless remote control signal light-sensing area, it means that the wireless remote control's batteries have run
down. Replace the batteries.
Multiple color bands (color bars) are displayed.

Press the [MODE] button to switch to the camera picture.
The menu screen is displayed.

Press the [MENU] button for 2 seconds to exit the camera menu.
Something is wrong with the coloring of the pictures.

Refer to "Auto tracking white adjustment (ATW)" and switch to "ATW".
When performing operations from a controller (AW-RP60/AW-RP150).
The unit does not move.

- Select the unit to be operated by referring to the operating instructions for the controller.
- if the unit's status display lamp is off or lights up orange, it means that the unit's power is not on. Refer to "Turn
the power on", and turn on the power.
- Check that the account settings for this unit have been set correctly.
- Network connection with AW-RP60/AW-RP150 requires setup of an initial account. When an initial account is
not set up, AW-RP60/AW-RP150 can detect but cannot control this unit.
Multiple color bands (color bars) are displayed.

Switch to the camera image by pressing the <BARS> button.
Something is wrong with the coloring of the camera pictures.

Refer to "Auto tracking white adjustment (ATW)", and switch to [ATW].
42