Installing Memory - Lexmark Optra E312 User Manual

Installing memory

system board shield
14
Chapter 1: The basics
Removing the
To install a memory card or a flash memory card, go on
to the next section. Otherwise, you are ready to set up
your application software and install the appropriate
printer driver. Refer to the booklet that came with the
Drivers, MarkVision and Utilities CD for installation
instructions. Go to
Printer drivers
about the printer utilities and drivers.
Your printer comes with 4MB of printer memory. You
can buy and install a 4MB, 8MB, 16MB, 32MB or 64MB
optional memory card for a total of 68MB of printer
memory.
You can also install a 1MB, 2MB or 4MB optional flash
memory card for storing downloaded fonts or macros.
Before installing any of these option cards, you will
need a small Phillips screwdriver to remove the metal
shield covering the printer system board.
1 Turn off the printer and unplug the power cord
from the printer.
2 Disconnect the printer cable (if attached) from
the printer.
3
Remove the print cartridge and cover it.
for more information