Table of Contents
Advertisement
ventilated area. * If in an enclosed area, vent
the exhaust to the outside. For more
information go to www.P65warings.ca.gov.
WARNING
This product can expose you to chemicals
including Lead, which is known to the State of
California to cause cancer and birth defects or
other reproductive harm. For more information
go to www.P65warings.ca.gov.
USE AND CARE
•
Do not modify this unit in any way.
Unauthorized modification may impair the
TECHNICAL SPECIFICATIONS
Power Supply
No-Load Voltage
Output Range
Duty Cycle
Compressed Air Required
Dimensions
Weight
DESCRIPTION
The Matco Tools MPPC70 is a Dual Voltage, DC
Inverter Plasma Cutter. It uses new state of the
art technology.
from 15 to 45 Amps. This unit is designed to cut
up to 11/16" steel at a travel speed of 10 inches
per minute when operating on 230V AC power.
Use the included adapter cord to run this unit off
120V AC power for a cutting capacity on steel of
up to 1/4" at a travel speed of 10 inches per
minute. It cuts all electrically conductive
materials. See chart below.
narrow
Page 6 of 16
Item
120V, 15A, 50/60 HZ, Single Phase
230V, 45A, 50/60 HZ, Single Phase
310 Volts DC
120V, 15A-23A
230V, 15A-45A
120V, 35% @ 23A
230V, 40% @ 45A
4.5 CFM @ 60psi - DO NOT SUPPLY MORE THAN 100psi
18.58 x 7.32 x 13.46
22.93 lbs.
The output can be adjusted
It cuts with a
function and/or safety and could affect the
life of the equipment. There are specific
applications for which this unit was
designed.
•
Always check for damaged or worn out
parts before using this unit. Broken parts
will affect the operation. Replace or repair
damaged or worn parts immediately.
•
Store idle. When this unit is not in use,
store it in a secure place out of the reach of
children. Inspect it for good working
condition prior to storage and before re-
use.
Description
kerf that results in a smaller heat affected zone
for reduced warping.
lightweight (22.93 lbs.), compact, inverter design
for greater portability. It has a pilot arc for easy
starts and enables the user to cut fence or
expanded metal.
This unit has a built-in air
pressure adjustment and gauge, indicator lights
for quick trouble shooting and thermal overload
protection and now features a built-in water
separator. The electrode, nozzle, diffuser ring
and protective cap are consumable items and
available through your Matco distributor.
The MPPC70 is
2004058-12
Advertisement
Table of Contents
