Table of Contents
Advertisement
Servicing the Cisco UCS X440p PCIe Node
What to do next
Choose the appropriate option:
•
•
•
Installing Riser, Type B
Use the following procedure to install a Type B riser onto the PCIe node.
Before you begin
You will find it helpful to gather a #2 Phillips screwdriver before starting this procedure.
Step 1
Orient the riser cage with the PCIe node so that the two thumbscrews are closest to the front of the node.
Step 2
Attach the riser cage to the PCIe node.
a) While lowering the riser cage onto the node, align the two guide holes on the cage with their respective guide pins
on the PCIe module.
Make sure that the cables are not pinched by the riser cage.
Note
b) Lower the riser cage onto the PCIe module making sure to align the thumbscrews with the correct screw holes.
c) Connect the MCIO cable to the rear mezzanine (MEZZ) connector.
d) Connect the power cable to the node's rear motherboard connector.
Removing a HHHL GPU, on page 32
Installing a HHHL GPU, on page 36
Installing Riser, Type B, on page 25
Cisco UCS X440p PCIe Node Installation and Service Guide
Installing Riser, Type B
25
Advertisement
Table of Contents
