Removing Riser, Type B - Cisco o UCS X440p Installation And Service Manual

Removing Riser, Type B

Removing Riser, Type B
Each PCIe node can contain a maximum of two PCIe riser cages of either type. Use this procedure to remove
a Type B riser.
Before you begin
You will find it helpful to have a #2 Phillips screwdriver for this procedure.
Step 1
Remove the PCIe node from the server.
See Removing the PCIe Node, on page
Step 2
Remove the top cover.
See Removing a PCIe Node Cover, on page
Step 3 Detach the riser cage from the PCIe node.
a) Using a #2 Phillips screwdriver, loosen the three captive thumbscrews.
b) Disconnect the MCIO cable from the rear mezzanine (MEZZ) connector.
c) Lift and slide the riser cage slightly to expose the rear mezzanine connector of the power cable.
d) Disconnect the power cable from the node's rear motherboard connector.
e) When both cables are disconnected, lift the riser cage off of the PCIe node.
Cisco UCS X440p PCIe Node Installation and Service Guide
24
12.
18.
Servicing the Cisco UCS X440p PCIe Node