TA Instruments DHR Series Getting Started Manual page 10

Peltier plate
Hide thumbs Also See for DHR Series:
Table of Contents

Advertisement

Typical temperature ranges for different cooling fluid configurations are given in the
"System
Specifications"
section.
The flow rate of the fluid through the bath does not need to be high. A flow rate of at 0.5 liters per minute
is usually adequate, although this should be increased to 1 liter per minute when working at very low tem-
peratures. If this flow rate is not maintained, the Peltier will lose the ability to provide cooling.
Measuring systems available for use with the Peltier Plate are the cone and plate and parallel plate.
DHR/AR Series Peltier Plate Getting Started Guide
Page 10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ar series

Table of Contents