Tools Required; Removing The Outer Cover - Agilent Technologies PSG Series Installation Notes

Removing Outer and Inner Covers

Tools Required

• T-10 driver
• T-15 driver
• T-20 driver

Removing the Outer Cover

Refer to Figure 1.
1. Disconnect the power cord.
2. Using a T-20 driver, remove the two strap handles (1) by loosening the screws (2).
3. Using a T-15 driver, remove the center screws (3) on the four rear-panel feet (4).
4. Remove the four bottom feet (5) from the cover by pulling the tab and pushing the foot.
5. Slide the outer cover (6) off the frame.
Removing the Inner Top Cover
Refer to Figure 2.
1. Using a T-10 driver, remove the ten screws (1) from the inner-top cover (2).
2. Remove the inner-top cover.
6