Installation; Find Most Suitable Location; Requirement On Straight Pipe Line - Bell VFM60 Series User Introduction Manual

2 Installation

2.1 Find Most Suitable Location

(1) Ambient temperature
Please avoid installing the flowmeter at a location where temperature could dramaticly changes. If
the meter is under heavy heat radiation, please implement effective heat insulation and venting method.
(2) Atomosphere
Please do not install the meter at a locaition where the atomosphere contains a high level of
corrosive substance. If can not install the meter at a better location, please make sure there is enough
venting.
(3) Vibration
The meter should not be installed at a location where could have strong vibration. If the mounting
pipeline could have heavy vibration, the pipe line should be hold steady by some support racks.
(4) Caution
(a) All screws and bolts should be tighen.
(b) Make sure there is not leakage point on the connection.
(c) The process pressure should not be higher than the meter's rated pressure.
(d) Once the meter is under pressure, please do not screw the bolts and screws.

2.2 Requirement on straight pipe line

Standard
Down sized
Date:24/04/2020
6 / 59
VFM-60
Vortex Flowmeter
Rev1.3
User's Manual