Remark - Bell VFM60 Series User Introduction Manual

Err-014 Reset code setting failed
Err-015 Reset digital setting failed
Err-016 Read total flow error
Err-017 Temperature calibration setting is wrong
Err-018 pressure calibration setting is wrong
Err-020 Flow rate limit setting is incorrect
Err-021 Temperature limit setting is incorrect
Err-022 Pressure limit setting is incorrect
Err-023 Communication connection error
Setting is incorrect when using aga_nx_19 to
Err-024
calculate the compressibility factor
Err-025 Frequency output for total flow is over limit
Err-026 3V power source failure
Err-027 Frequency output incorrect
Err-028 The master is disconnected from the slave

10 Remark

No part of this publication may be copied or distributed, transmitted, transcribed, stored in a
retrieval system, or translated into any human or computer language, in any form or by any means,
electronic, mechanical, manual, or other wise, or disclosed to third parties without the express writeen
permission of our company. The information contained in this manual is subject to change without
notice.
Date:24/04/2020
Check EEPROM
Check EEPROM
Check EEPROM
Check the record of temperature calibration
Check the record of pressure calibration
Check the flow rate limit setting
Check the temperature limit setting
Check the pressure limit setting
Check the communication link
Check if the setting for compressibility factor
is correct
Reset the total flow frequency output factor
Check the circuit board
Check the range of frequency
Check the cable wiring between local and
remote transmitter
47 / 59
VFM-60
Vortex Flowmeter
Rev1.3
User's Manual