Digital Setting - Bell VFM60 Series User Introduction Manual

same time. Please reference to picture 5.1.
When in code setting, the first row will display the reference number fo the code setting, and the
lower row will display the contents of this parameter. The digit that is flashing is the digit under
setting. Please reference to picture 5.2, which means C01=02, means fluid type is liquid.
When under code setting, Now ,user can use "L-R button" to choose which digit on the displayer
are to be set , and use "R-D button" to switch the digit to 0~9 . The first time of pressing "Enter
button" means to set the lower row. Press "Enter button" again to check if the setting is available. If
setting is available, the setting made will be canceled and the display will not flash, then press "L-R
button" or "U-D button" to set again. When display is not flashing, pressure "Enter button" to save
and go to next setting.
If want to quit code setting, same as entering, please hold "Enter button" then press "U-D button"
at the same time.

5.1.2 Digital setting

Under working status, to enter code setting, please hold "Enter button" then press "L-R button" at the
same time. Please reference to picture 5.3.
Date:24/04/2020
Picture 5.1 enter and quit code setting
Picture 5.2 code setting
20 / 59
VFM-60
Vortex Flowmeter
Rev1.3
User's Manual