Configure The Srtp Settings; Configure The Mqtt Settings - i-PRO WV-S71300-F3 Operating Instructions Manual

•
Default: Off
Note
•
If you are concerned about delays of the video display, select Off.

3.10.2.9 Configure the SRTP settings

The settings relating to the SRTP funtion are configured in this section.
[SRTP]
Select "On" or "Off" to determine whether or not to use the SRTP function.
•
On: Use the SRTP function
•
Off: Not use the SRTP function
•
Default: Off
Note
•
RTP distribution is available even when SRTP is set to "On".
•
Information on clients that can connect with SRTP is available on our technical information website
<Control No.: C0318>.

3.10.2.10 Configure the MQTT settings

The settings relating to MQTT (Message Queueing Telemetry Transport) can be configured on this page.
[MQTT settings]
Set On/Off whether to enable/disable the MQTT function.
When set to "On", or it is "On" when the camera starts up, it will connect to the set server.
When the set alarm occurs, the settings will be notified to the server.
•
Default: Off
Server
[Address]
Enter the IP address or host name of the MQTT server to be notified when an alarm occurs.
•
Available number of characters: 1 - 128 characters
•
Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
•
Default: None (blank)
[Port number]
Enter a port number of the MQTT server.
•
Available port number: 1 - 65535
•
Default: 8883
IMPORTANT
•
The following port numbers are unavailable since they are already in use.
20, 21, 22, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670
[Protocol]
Select the protocol to use when connecting to an MQTT server from MQTT over SSL/MQTT over TCP.
•
Default: MQTT over SSL
3 Detailed Settings
Operating Instructions 149