Configure Advanced Network Settings [Advanced]; Configure The Settings Related To Sending E-Mails - i-PRO WV-S71300-F3 Operating Instructions Manual

3 Detailed Settings

3.10.2 Configure advanced network settings [Advanced]

Click the [Advanced] tab on the "Network" page. (®"3.2.1 How to display the setup menu", "3.2.2 How to
operate the setup menu")
The settings related to SMTP (E-mail), NTP, UPnP, HTTPS, DDNS, SNMP, QoS, SRTP can be configured in
this section.
You can move to the setting page of a setting item by clicking the corresponding link for that setting item.

3.10.2.1 Configure the settings related to sending E-mails

[E-mail notification]
Select "On" or "Off" to determine whether or not to provide notification by E-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of notification" below.
–
When an alarm is detected ("Alarm")
–
When a notification of the remaining capacity of the SD memory card has been provided ("Diag.")
–
When the SD memory card has become full ("Diag.")
–
When the SD memory card cannot be recognized ("Diag.")
–
When deviation from the initial angle of view is detected, and when the deviation is corrected
•
Default: Off
[Alarm image attachment]
Select "On" or "Off" to determine whether or not to attach an image to the E-mail to be sent when an alarm is
detected.
•
Default: Off
[Image capture size]
Select the image capture size of images attached to an alarm E-mail from the following.
JPEG(1)/JPEG(2)
•
Default: JPEG(2)
[SMTP server address]
Enter the IP address or the host name of the SMTP server used to send E-mails.
•
Available number of characters: 1 - 128 characters
•
Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
[SMTP port]
Enter the port number to which E-mails are sent.
•
Available port number: 1-65535
•
Default: 25
The following port numbers are unavailable since they are already in use.
20, 21, 22, 23, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[POP server address]
When "POP before SMTP" is selected for "Type", enter the IP address or the host name of the POP server.
•
Available number of characters: 1 - 128 characters
134 Operating Instructions