A
G.6
Fastening multiple appliances together
Remove lower panel A by undoing the screws.
1
A
A
A
3. Remove the transport pallet.
4. Carry the appliance on the lifting cart to the prepared
position on the wall and lift it to the correct height.
5. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive solvent.
Then rinse and dry the spot thoroughly.
Push the units together. Use the adjusting screws
2
on the feet to bring the appliances to the same
height, then level them.
Screw the appliances together at the base using the
screw, washer and nut B. Replace panel A using
the screws.
B
A
A
21