Table of Contents
Advertisement
ø10
F.8
Wall installation
F.8.1
Preparing the brackets and set up
Before you start, prepare the mounting holes in the wall
according to the specifications in the mounting diagram.
1. Use the supplied wall anchors with the threaded rods A.
The holes must have a diameter of 18 mm [0,71"] and a
minimum depth of 145 mm [5,71"].
Wall anchors with long threaded rods must be positioned
at the top, those with short rods must be positioned at the
bottom.
2. Clean the hole after drilling.
3. Tighten wall anchor nuts B to a torque of 80 Nm.
4. Then fit nuts C and washers G and screw in the supporting
bracket E at a distance of 30 mm [1,18"].
5. Align all support brackets E correctly.
6. Level the set screws F in the support brackets E.
7. Lift the unit on the wall anchor threaded bolts and level it
using a spirit level.
8. Finally fix it with washers G and nuts C and fit the lock nut
D.
145 mm
ø18
A
145 mm
A
F.8.2
Positioning
CAUTION
All wall-mounted appliances are posi-
tioned on the transport pallet so that the
wall-side of the unit is lying on the trans-
port pallet.
We recommend using a lifting truck with a stable shelf to take
the unit down from the transport pallet and position it into place.
IMPORTANT
Remove the bottom cover before placing the
appliance on the pallet (refer to paragraph E.5
Accessing the appliance's internal components).
1. Transport the appliance on its transport pallet directly in
front of the point of installation.
ø10
80 mm
G
D
M12
C
B
30
B
E
F
Bring the lifting cart as close as possible to the appliance.
2. Carefully turn the unit on shelf A of the truck to the
horizontal position and remove the transport pallet.
3. Remove covers and inspection panels to allow for elec-
trical and water connections, refer to the paragraph E.5
Accessing the appliance's internal components.
4. Carry the appliance on the lifting cart to the prepared
position on the wall and lift it to the correct height.
5. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive
solvent.
Then rinse and dry the spot thoroughly.
A
CAUTION
When successful installation is complete
reattach all the panels.
F.9
Fastening multiple appliances together
IMPORTANT
Do not install the side panels on the sides where the
appliances are mounted together.
A
A
19
Advertisement
Table of Contents
Troubleshooting
