Table of Contents
Advertisement
D.10 Characteristics of personnel enabled to
operate on the machine
The Customer is responsible for ensuring that persons
assigned to the various duties:
• read and understand the manual;
• receive adequate training and instruction for their duties in
order to perform them safely;
• receive specific training for correct machine use.
D.11 Operator qualified for normal machine
use
Must have at least:
• knowledge of the technology and specific experience in
operating the machine;
E
TRANSPORT, HANDLING AND STORAGE
E.1
Introduction
Transport (i. e. transfer of the machine from one place to
another) and handling (i. e. transfer inside workplaces) must
occur with the use of special and adequate means.
CAUTION
The machine must only be transported, handled and stored
by specialised personnel, who must have:
• specific technical training and experience in the use of
lifting systems;
• knowledge of the safety regulations and applicable laws
in the relevant sectors;
• knowledge of the general safety rules;
• personal protection equipment suitable for the type of
operation carried out;
• the ability to recognize and avoid any possible hazard.
E.2
Transport
CAUTION
Before moving the appliance make sure
the load bearing capacity of the lifting
equipment used is suitable for its weight.
Due to the appliance dimensions it is possible to stack the
appliances on top of each other during transport, by complying
with that specified on the slip placed on the packing.
The manufacturer shall under no circumstances be liable for
damage during transport or damage to the packaging.
E.3
Handling
Arrange a suitable area with flat floor for machine unloading
and storage operations.
E.3.1
Procedures for handling operations
Before lifting:
• send all operators to a safe position and prevent persons
from entering the handling area;
F
INSTALLATION DIAGRAMS
F.1
Dimension drawings for floor installations
CAUTION
When installing with concrete plinth, the wall niche must be at least 70 mm deep but must not
exceed 100 mm to ensure the appliance has a solid base and sufficient ventilation inside it.
• adequate general basic education and technical knowledge
for reading and understanding the contents of the manual,
including correct interpretation of the drawings, signs and
pictograms;
• sufficient technical knowledge for safely performing his
duties as specified in the manual;
• knowledge of the regulations on work hygiene and safety.
In case of a significant anomaly (e. g. short circuits, wires
coming out of the terminal block, motor breakdowns, worn
electrical cable sheathing, etc.) the operator for normal
machine use must:
• immediately deactivate the machine and disconnect all the
supplies (electricity, gas, water).
• make sure the load is stable;
• make sure no material can fall during lifting. Manoeuvre
vertically in order to avoid impacts;
• handle the machine, keeping it at minimum height from the
ground.
For correct and safe lifting operations:
• use the type of equipment most suitable for characteristics
and capacity (e.g. electric pallet truck or lift truck);
• cover sharp edges;
• check the forks and lifting procedures according to the
instructions given on the packing.
E.3.2
Shifting
The operator must:
• have a general view of the path to be followed;
• stop the manoeuvre in case of hazardous situations.
E.3.3
Placing the load
Before placing the load, make sure the way is free and that the
floor is flat and can take the load.
For more information please refer to the installation chapter.
E.4
Storage
The machine and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between 5℃ and 50℃.
The place where the machine is stored must have a flat
support surface to avoid deforming the machine or damage to
the support feet.
CAUTION
Do not make modifications to the parts
supplied with the appliance. Any missing
or faulty parts must be replaced with
original parts.
15
Advertisement
Table of Contents
