Table of Contents
Advertisement
G.4.4
Securing or adjusting to the floor (optional)
If you need to secure it to the floor, the appliance comes with compatible adjustable feet.
We recommend you adjust the feet so you end up with a working height of 900 mm. Level the unit with a spirit level.
Attaching the unit with screws
The feet have metal plates which may be secured to the floor
using screws .
G.5
Wall installation
G.5.1
Preparing the brackets
Before you start, prepare the mounting holes in the wall
according to the specifications in the mounting diagram.
1. Use the supplied wall anchors 1 with the threaded rods 2.
The holes must have a diameter of 18 mm [0,71"] and a
minimum depth of 145 mm [5,71"].
2. Clean the hole after drilling.
3. Mount the supporting profile 3 with the nuts 4 and the
spring washers 5.
4. Adjust the supporting profile 3 in height and alignment
using a spirit level.
3
4
2
5
G.5.3
Positioning
We recommend using a lifting truck with a stable shelf to take the unit down from the transport pallet and position it into place.
Lifting the unit onto the hand truck has to be done by hand, with two or more men required depending on the unit size.
20
1
145
1
A
Attaching the unit by welding
The metal plate underneath the feet must be welded to the
floor with a continuous weld around the outer edge.
G.5.2
Securing and set up
Lift the unit on the prepared support profile and level it using a
spirit level. Check the height in relation to other devices.
Use the adjusting screws 6 to adjust the device vertically.
Finally, tighten wall anchor nuts 4 to a torque of 80 Nm.
4
1. Transport the appliance on its transport pallet directly in
front of the point of installation.
Bring the lifting cart as close as possible to the appliance.
2. Carefully lift the unit on shelf A of the truck.
2
6
Advertisement
Table of Contents
