Table of Contents
Advertisement
H.6
Water filling automatic
The automatic water filling system, if available on your model,
fills up the appliance with a volume of water set by means of
the touch panel, refer to K.3.5.4 Water filling automatic.
If this option is present, one tap knob is dedicated to automatic
water filling and the other is for manual water flow.
You can have an automatic filling of cold water only, or an
automatic filling of hot and cold water.
IMPORTANT
Remember that if you want to use the automatic
filling function (using the touch panel), the dedi-
cated knob must be open, otherwise the water
cannot flow.
With cold only water filling option:
• The knob dedicated to automatic filling is the blue one.
I
NORMAL APPLIANCE USE
I.1
Characteristics of personnel enabled to
operate on the appliance
The Customer must make sure the personnel for normal
appliance use are adequately trained and skilled in their duties.
The operator must:
• read and understand the manual;
• receive adequate training and instruction for their duties in
order to operate safely;
• receive specific training for correct appliance use.
IMPORTANT
The Customer must make sure his personnel have
understood the instructions received and in partic-
ular those regarding work hygiene and safety in use
of the appliance.
J
PRODUCT DESCRIPTION
J.1
Use
The appliance is intended for industrial use by trained
personnel.
This appliance must only be used for its expressly designed
purpose, i.e. for cooking, braising, browning, roasting, boiling,
stewing.
Any other use is considered improper.
IMPORTANT
For the "boiling cooking" fill the appliance with food
for at least 40 mm [1,57"], otherwise it could burn. If
the filling level is less than 40 mm, deviations in the
temperature display may occur. With a lower fill
level activate the "Soft cooking" function, refer to
paragraph K.3.5.3 Soft cooking.
The appliance has 2 heating zones that can be individually
controlled, refer to paragraph K.3.5.5 Multizone function.
The appliance is GN compliant.
WARNING
Stand back when you open the
lid or the steam outlet, because
hot steam could pour out.
CAUTION
Do not switch on the appliance when it is
empty.
• Through the red knob, you can manually run hot water.
With hot or cold water filling option:
• The knob dedicated to automatic filling is the red one.
• If the red knob is open, you can select automatic hot or cold
water filling by means of the touch panel.
• Through the blue knob, you can manually run only cold
water.
H.7
Water filling automatic for "Sprint"
models only
On "Sprint" models, the automatic water filling system is
always already set up with hot and cold water through the
swiveling arm, so there is no need to open knobs but simply
activate it through the touch control panel, refer to K.3.5.4
Water filling automatic.
I.2
Basic requirements for appliance use
• Knowledge of the technology and specific experience in
operating the appliance.
• Adequate general basic education and technical knowledge
for reading and understanding the contents of the manual,
including correct interpretation of the drawings, signs and
pictograms.
• Sufficient technical knowledge for safely performing his
duties as specified in the manual.
• Knowledge of the regulations on work hygiene and safety.
NOTE!
The temperatures required for the cooking pro-
cesses give rise to intense overheating of some
components.
This is not due to a design fault, but is a
consequence of the thermal conductivity of stain-
less steel.
The maximum filling level must not exceed the relevant
marking, i. e. not more than 40 mm below the upper edge of
the pan.
Refer to A.4 ProThermetic general safety.
J.2
Appliance overview
13
12
8
9
10
11
1. Lid
2. Cover
3. Touch control panel
1
2
3
4
5
7
6
23
Advertisement
Table of Contents
Troubleshooting
