Normal Machine Use; Machine Cleaning And Maintenance - Electrolux E9BSGLIUFE Spare Parts Diagram

ATTENTION!
The previously described actions are prohibited!
1.2.6 RESIDUAL RISKS
The machine has several risks that were not completely
eliminated from a design standpoint or with the installation
of adequate protection devices. Nevertheless, through this
manual the Manufacturer has taken steps to inform operators
of such risks, carefully indicating the personal protection
equipment to be used by them. Sufficient spaces are provided
for during the machine installation stages in order to limit
these risks. To preserve these conditions, the areas around
the machine must always be:
• kept free of obstacles (e.g. ladders, tools, containers, boxes, etc.);
• clean and dry;
• well lit.
For the Customer's complete information, the residual risks
remaining on the machine are indicated below: such actions
are to be considered incorrect and therefore strictly forbidden.
RESIDUAL DESCRIPTION OF HAZARDOUS
RISK
Slipping or The operator can slip due to water or dirt
falling
Burns/
The operator deliberately or unintentionally
abrasions
touches some components inside the
(e.g. heating
machine without using protective gloves.
elements)
Contact with live parts during maintenance
Electrocution operations carried out with the electrical
Sudden
The operator for normal machine use could
closing of the
suddenly and deliberately close the lid
lid
When handling the machine or the packing
Tipping of containing it, using unsuitable lifting
loads systems or accessories or with the load
SITUATION
on the floor.
panel powered.
unbalanced.

2. NORMAL MACHINE USE

2.1 CHARACTERISTICS OF PERSONNEL TRAINED FOR
NORMAL MACHINE USE
The Customer must make sure the personnel for normal
machine use are adequately trained and skilled in their
duties, as well as ensuring their own safety and that of other
persons. The Customer must make sure his personnel have
understood the instructions received and in particular those
regarding work hygiene and safety in use of the machine.
2.2 CHARACTERISTICS OF PERSONNEL ENABLED TO
OPERATE ON THE MACHINE
The Customer is responsible for ensuring that persons
assigned to the various duties:
• read and understand the manual;
• receive adequate training and instruction for their duties in
order to perform them safely;
• receive specific training for correct machine use.
2.3 OPERATOR FOR NORMAL USE
He must have at least:
• knowledge of the technology and specific experience in
operating the machine;
• adequate general basic education and technical knowledge
for reading and understanding the contents of the manual;
• including correct interpretation of the drawings, signs and
pictograms;
• sufficient technical knowledge for safely performing his
duties as specified in the manual;
• knowledge of the regulations on work hygiene and safety.
In case of a significant fault (e.g. short circuits, wires coming
out of the terminal block, motor failures, worn electrical cable
sheathing, etc.), the operator for normal machine use must:
• immediately deactivate the machine.

3 MACHINE CLEANING AND MAINTENANCE

ATTENTION!
Before carrying out any cleaning or maintenance
operation, disconnect the appliance from the
power supply by means of the device lockable
in open position.
ATTENTION!
During maintenance, the cable and plug must
be kept in a visible position by the operator
carrying out the work.
ATTENTION!
Do not touch the appliance with wet hands
or feet or when barefoot. DO NOT remove the
safety guards.
ATTENTION!
Use suitable personal protection equipment
(protective gloves).
35