Printing Photos From A Pictbridge-Enabled Digital Camera - Lexmark S315 User Manual

Printing

Printing photos from a PictBridge-enabled digital camera

PictBridge is a technology available in most digital cameras that lets you print directly from your digital camera without
using a computer.
1
Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the camera.
2
Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
• Make sure that the digital camera is set to the correct USB mode. If the camera USB selection is incorrect,
then the camera is detected as a flash drive, or an error message is displayed on the printer control panel.
For more information, see the documentation that came with the camera.
•
The printer reads only one memory device at a time.
3
If the PictBridge connection is successful, then the following message appears on the display: Use PictBridge
Device to choose and print photos. Press OK to select printer default
settings.
4
If you want to change the default print settings:
a
Press to access the PictBridge menu.
OK
b
Press the arrow buttons to select the paper source, paper setup, photo size, number of photos per page and
print quality. You can also enhance the quality of graphics. Press
Note: The printer will use the default print settings unless you change the print settings from the camera.
5
See the documentation that came with the camera to begin printing.
Note: If you insert the USB cable of the PictBridge‑enabled camera while the printer is performing another job, then
wait for the job to finish before printing from the camera.
Warning—Potential Damage: Do not touch any open connector, the memory
device, or the printer in the areas shown while actively printing, reading, or
writing from the memory device. A loss of data can occur.
each time you make a selection.
OK
37