Table of Contents
Advertisement
2.3 EMX-TGLP Jumper and Connector List
You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper you connect the pins with the clip.
To "open" a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board's jumpers and connectors.
Jumpers
Label
Function
JRI1/2
Serial port 1/2 pin9 signal select
JSBKL1
LVDS Back Light power selection
JSATX1
AT/ATX Power Mode Select
M2KB1 Voltage setting
JP1
JBAT1
Clear CMOS
Connectors
Label
Function
FPT1
Miscellaneous setting connector 1
FPT2
Miscellaneous setting connector 2
SODIMM1/2
206-pin DDR4 SO-DIMM socket
JFAUD1
Front Audio connector
Quick Reference Guide
Note
3 x 2 header, pitch 2.00mm
3 x 1 header, pitch 2.00mm
3 x 1 header, pitch 2.54mm
3 x 1 header, pitch 2.00mm
2 x 1 wafer, pitch 2.00mm
Note
5 x 2 header, pitch 2.54mm
5 x 2 header, pitch 2.54mm
6 x 2 header, pitch 2.00mm
OFP-21W38 Quick Reference Guide 43
Advertisement
Table of Contents
