Emx-Tglc Jumper And Connector List - Avalue Technology APC-2138 Quick Reference Manual

2.3 EMX-TGLC Jumper and Connector List

You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper you connect the pins with the clip.
To "open" a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board's jumpers and connectors.
Jumpers
Label Function
JRI1/2 Serial port 1/2 pin9 signal select
JSBKL1 LVDS Back Light power selection
AT/ATX Power Mode Select
JSATX1
JP1 M2KB1 Voltage setting
JBAT1 Clear CMOS
Connectors
Label Function
FPT1 Miscellaneous setting connector 1
FPT2 Miscellaneous setting connector 2
206-pin DDR4 SO-DIMM socket
SODIMM1/2
JFAUD1 Front Audio connector
LCD Inverter connector
JBKL1/2
Quick Reference Guide
Note
3 x 2 header, pitch 2.00mm
3 x 1 header, pitch 2.00mm
3 x 1 header, pitch 2.54mm
3 x 1 header, pitch 2.00mm
2 x 1 wafer, pitch 2.00mm
Note
5 x 2 header, pitch 2.54mm
5 x 2 header, pitch 2.54mm
6 x 2 header, pitch 2.00mm
5 x 1 wafer, pitch 2.00mm
APC-2138 Quick Reference Guide 15