Display Setup - Lexicon RV-5 User Manual

RV-5

DISPLAY SETUP

Selecting the SETUP menu DISPLAY SETUP option opens the DISPLAY SETUP menu, which is used to customize the OSD and front panel display,
and setup other display-related features.
MAIN MENU
AUDIO CONTROLS
VIDEO CONTROLS
SETUP
CONNECTION
CONNECTION

DISPLAY SETUP

SETUP
Selects the CONNECTION parameter, which identifies the active
video output connectors on the RV-5 rear panel. The following list of
conditions identify the behavior of this parameter.
• If ANALOG is selected, only the analog video connectors are
available and will output the video signal.
• If HDMI/DVI is selected, both the analog and HDMI video
connectors are available and will output the video signal.
• If the video input is set to HDMI and the CONNECTION
parameter is set to ANALOG, then no video is output.
• If the HDMI video input is copy-protected (HDCP), no video is
output on the analog output connectors. This is a requirement
of HDCP and not a limitation of the RV-5 Receiver.
SETUP
DISPLAY SETUP
DISPLAY SETUP
CONNECTION: HDMI/DVI
SPEAKER/EQ SETUP
HDMI AUDIO OUT: NO
INPUT SETUP
ON-SCREEN DISPLAY
SURROUND CONFIG
FRONT PANEL DISPLAY
DOLBY CONFIG
MUTE LEVELS
POWER ON SETTINGS
ANALOG, HDMI/DVI
ON-SCREEN DISPLAY
2-LINE OSD: 3s
MENU TIME OUT: 30s
FRONT PANEL DISPLAY
BRIGHTNESS: FULL
TIME OUT: NONE
HDMI AUDIO OUT
HDMI AUDIO OUT
SETUP DISPLAY SETUP
Selects the HDMI AUDIO OUT parameter, which identifies if audio is
sent on the HDMI output. If the HDMI AUDIO OUT parameter is set
to YES, then a two-channel DOWN MIX of the source audio is sent
over the HDMI connection at the maximum bit rate of the display's
audio system. This audio stream is in addition to the normal audio
outputs. If the parameter is set to NO, this audio is not sent.
2-LINE OSD
ON-SCREEN DISPLAY
SETUP DISPLAY SETUP
Selects the 2-LINE OSD parameter from the On-Screen Display (OSD)
menu. The 2-Line OSD parameter identifies the length of time that
the 2-line OSD is displayed and can be set to display from three to six
seconds in one-second increments. If OFF is selected, then the 2-line
OSD is not displayed.
Note: If OFF is selected, the menu screens are still displayed. This
parameter only affects the 2-line OSD display, which is identical to the
front panel 2-line display.
Setup
YES, NO
OFF, 3, 4, 5, 6 SECONDS
2-LINE OSD
3-3