Table of Contents
Advertisement
Installation
Electrical connection
o
Installation of the induction hob should be performed by specialized personnel and carried out in compliance
-
with current regulations� Make sure that the parts in tension underneath the hob are protected� The outline for
è
the electrical connection is indicated on the label near the terminal board� In case of direct connection to the
network it will be necessary to interpose an omnipolar switch with a minimum opening between the contacts
of 3 mm� Connection to the electrical network must be separated by the appropriate interruption: switch, fuse�
Connecting cable to hob
With respect to the various types of connection, you should utilize the appropriate jumpers placed inside the
,
jumper board�
MONOPHASE: connect the jumper to clamps 1-2 and 2-3� The phase should be connected to clamp 1 or 2� The
o
neutral should be connected to clamps 4-5�
2 PHASES + N: connect the jumper to clamps 2 or 3 and between clamps 4-5, one phase to clamp 1 and one
phase to clamp 2 or 3�
3 PHASES + N: connect the jumper to clamps 4-5� Connect the neutral to clamp 4 or 5, one phase to clamp
1, one phase to clamp 2 and one phase to clamp 3�
POWER
230V a�c� 1P+N 50Hz
400V a�c� 2P+N 50Hz
400V a�c� 3P+N 50Hz
The manufacturer will not be held liable for any damages due to improper electrical connections
18
Always connect the earthing cable.
Comply with the connection instructions.
The terminal board is located under the hob at the back. Use a screwdriver to
open the cover of the terminal board.
Electrical cable table
CONNECTIONS
1 phase + N
2 phase + N
3 phase + N
(*) calculated using the coincidence factor 60 335-2-6
WIRING
TYPE OF WIRING
3 x 6 mm
H07RN
2
4 x 2,5 mm
H05RR
2
5 x 1,5 mm
H05RR
2
FUSES
25 A*
16 A*
16 A*
Advertisement
Table of Contents
