Table of Contents
Advertisement
Maintenance and cleaning
• Switch the appliance off before cleaning it�
• Do not clean the glass while it is still hot; you could burn yourself�
• Remove small stains with a damp cloth and then finish off with a dry cloth.
• Do not use corrosive or abrasive products to clean the appliance�
• Do not use any object that could ruin the glass-ceramic surface�
• Make sure that the bottom of the pot is dry and clean and that the glass surface is not dirty� Moving the pot
could scratch the glass�
• Immediately remove any sugar, gelatine or marmalade to prevent damage to the glass�
Controls to carry out in case of malfunction
Anomaly
The appliance and the hob do not
switch on
The "U" symbol appears on the display
The "F" symbol appears on the di-
splay
The "E" symbol appears on the di-
splay
The cooking zones do not work
If ventilation remains on when the
hob is switched off
16
• The hob has not been properly connected to the electrical network�
• The protection fuse is broken�
• The safety key has been turned on�
• The "key" knob is greasy or covered by water�
• An object is leaning on the "key" knob�
• The pot was not placed on the cooking zone�
• The pot is not compatible with induction�
• The diameter of the bottom of the pot is too small�
• The cooking zone is unusable�
• Contact the authorized service centre�
• Electronic system is defective�
• Disconnect the hob from the electrical network�
• Contact the authorized service centre�
• The safety system is in operation�
• Check whether one or more knobs may be covered�
• The pot is empty and the bottom has overheated�
• This is not a malfunction� The ventilator continues to function to
protect the electronics�
• The automatic ventilation will stop automatically�
Causes
Advertisement
Table of Contents
