Set Up With The Display And Adjustment Module; Insert Display And Adjustment Module - Vega SOLITRAC 31 Operating Instructions Manual

Radiometric sensor for continuous level and interface measurement

Hide thumbs Also See for SOLITRAC 31:

Table of Contents

6 Set up with the display and adjustment module

Mount/dismount display

and adjustment module

Set up with the display and adjustment

module

6.1

The display and adjustment module can be inserted into the sensor

and removed again at any time. It is not necessary to interrupt the

voltage supply.

Proceed as follows:

1. Unscrew the small housing cover

2. Place the display and adjustment module in the desired position

on the electronics (you can choose any one of four different posi-

tions - each displaced by 90°)

3. Press the display and adjustment module onto the electronics

and turn it to the right until it snaps in

4. Screw housing lid with inspection window tightly back on

Disassembly is carried out in reverse order.

The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Fig. 19: Insert display and adjustment module

Note:

If you intend to retrofit the instrument with a display and adjustment

module for continuous measured value indication, a higher lid with an

inspection glass is required.

SOLITRAC 31 • Profibus PA

Table of Contents