Set Up The Sensor With The Display And Adjustment Module; Adjustment Volume; Insert Display And Adjustment Module - Vega VEGAFLEX 86 Operating Instructions Manual

Tdr sensor for continuous level and interface measurement of liquids

Hide thumbs Also See for VEGAFLEX 86:

Table of Contents

6 Set up the sensor with the display and adjustment module

Set up the sensor with the display and

adjustment module

6.1

The display and adjustment module is only used for parameter adjust-

ment of the sensor, i.e. for adaptation to the measurement task.

The parameter adjustment of the Modbus interface is carried out via

a PC with PACTware. You can find the procedure in chapter " Set up

sensor and Modbus interface with PACTware".

6.2

The display and adjustment module can be inserted into the sensor

and removed again at any time. You can choose any one of four differ-

ent positions - each displaced by 90°. It is not necessary to interrupt

the power supply.

Proceed as follows:

1. Unscrew the housing lid

2. Place the display and adjustment module on the electronics in the

desired position and turn it to the right until it snaps in.

3. Screw housing lid with inspection window tightly back on

Disassembly is carried out in reverse order.

The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Fig. 21: Insertion of the display and adjustment module

Note:

If you intend to retrofit the instrument with a display and adjustment

module for continuous measured value indication, a higher lid with an

inspection glass is required.

VEGAFLEX 86 • Modbus and Levelmaster protocol

Table of Contents