Set Up With The Display And Adjustment Module; Insert Display And Adjustment Module - Vega VEGAFLEX 86 Operating Instructions Manual

Tdr sensor for continuous level and interface measurement of liquids

Hide thumbs Also See for VEGAFLEX 86:

Table of Contents

VEGAFLEX 86 • Two-wire 4 ... 20 mA/HART

Set up with the display and adjustment

module

6.1

The display and adjustment module can be inserted into the sensor

and removed again at any time. You can choose any one of four differ-

ent positions - each displaced by 90°. It is not necessary to interrupt

the power supply.

Proceed as follows:

1. Unscrew the housing lid

2. Place the display and adjustment module on the electronics in the

desired position and turn it to the right until it snaps in.

3. Screw housing lid with inspection window tightly back on

Disassembly is carried out in reverse order.

The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Fig. 20: Installing the display and adjustment module in the electronics compart-

ment of the single chamber housing

6 Set up with the display and adjustment module

Table of Contents