Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
45 degree grease fitting
Height of cut bracket assembly, R.H.
Height of cut bracket assembly, L.H.
Flange lock nut, 3/8 inch
Splined insert
Groomer shaft assembly
Shim washer (as required for belt alignment)
Socket head screws, 3/8 x 1 inch
Groomer belt
Idler spring
Rubber grommet ring (used only if rear roller
brush kit is installed)
Set screw (used only if rear roller brush kit is
installed)
Operator's Manual
Parts Catalog
No parts required
Traction Unit Requirements
The Right and Left Groomer Kit Models 03713 and 03714
can be used on Reelmaster 7000-D DPA Cutting Unit Models
03710 and 03711 with or without a Rear Roller Brush Kit.
Note: Determine the left and right sides of the machine
from the normal operating position.
Tools Required for Setup
•
5/16 socket
•
1/2 deep–well socket
•
9/16 deep-well socket
•
5/8 socket
•
3/8 wrench
•
1/2 wrench
•
9/16 wrench (2)
•
5/16 Allen wrench
•
5/32 mm Allen wrench
•
3/8-16 tap
•
Needle nose pliers
•
6 inch ruler, Toro Part No. 114–5446
•
12 inch straight edge
•
Flat screw driver
•
Vise clamp pliers
•
Torque wrench 15-19 ft-lb (20-26 N-m)
Qty.
1
1
1
2
1
1
1
4
Install the Groomer
1
1
1
1
1
1
–
Install the Broomer Kit (optional)
•
Torque wrench 27-33 ft-lb (36-45 N-m)
•
Torque wrench 34-40 ft-lb (46-54 N-m)
•
Torque wrench 85-95 ft-lb (115-129 N-m)
•
Reel drive shaft tool, Part No. TOR4074
•
Blue 242 Loctite
5
Use