Toro 03713 Operator's Manual page 11

Figure 18
1. Bearing housing
12. Remove the carriage bolts and nuts securing the height
of cut brackets to the cutting unit side plates
19).
13. Loosen the capscrews and locknuts securing the height
of cut brackets to the front roller shaft
14. Remove the height of cut brackets and the front roller
from the cutting unit side plates
Figure 19
1. Height of cut bracket
15. Loosely install the new right and left height of cut
brackets to the existing front roller with new 5/16
x 1-1/8 inch capscrews and 5/16 inch flange head
locknuts. Position the height of cut brackets as shown
in figure Figure 20.
Note: The left height of cut bracket is marked with
an "L" and the right height of cut bracket is marked
with a "R".
(Figure
(Figure 19).
(Figure 19).
2. Carriage bolt
1. Height of cut bracket
2. Capscrew & locknut
16. Using the upper square hole in each side plate, loosely
mount the height of cut brackets to the cutting unit
side plates with the carriage bolts previously removed
and new 3/8 inch flange nuts, positioning as shown
in figure Figure
Note: The washers on the height of cut adjusting
bolts must be located on each side of the flange on the
side plate (Figure
1. Washer
2. Locknut
17. Tighten the locknut on the height of cut adjuster bolt
until the washers contact the side plate flange, then
back-off the nut 1/2 turn
18. Center the roller between the brackets and lock in
place with the capscrews and locknuts on the brackets
(Figure 20).
19. Using the Reel Drive Shaft Tool, remove the splined
insert from the reel motor end of the reel shaft
22). Use Reel drive shaft tool, Part No. TOR4074.
11
Figure 20
3. Carriage bolt
20.
21).
Figure 21
3. Side plate flange
(Figure 21).
(Figure