Toro 03713 Operator's Manual page 7

Note: The washers on the height of cut adjusting
bolts must be located on each side of the flange on the
side plate (Figure 5).
10. Tighten the locknut on the height of cut adjuster bolt
until the washers contact the side plate flange, then
back-off the nut 1/2 turn
1. Washer
2. Locknut
11. Center the roller between the height of cut brackets
and lock it in place with the capscrews and locknuts
on the brackets (Figure
1. Height of cut bracket
2. Capscrew & locknut
12. Using the Reel Drive Shaft Tool, remove the splined
insert from the reel motor end of the reel shaft
7). Use Reel drive shaft tool, Part No. TOR4074.
Clean all the grease out of the threaded hole where the
splined insert was.
Important: The splined insert on the left hand
side of the cutting unit has left hand threads. The
(Figure 5).
Figure 5
3. Side plate flange
6).
Figure 6
3. Carriage bolt
splined insert, on the right hand side of the cutting
unit, has right hand threads.
13. Install the new (longer) splined insert to the reel shaft
(Figure
insert prior to installation. Torque to 85-95 ft-lb
(115–129 N-m).
1. Splined insert
14. On the non-drive side of the groomer assembly, slide
the groomer plate with quick-up lever off the groomer
shaft assembly
15. Using a 3/8-16 tap, remove the paint in the outer
mounting holes in both the left and right side plates
(Figure
16. On the drive side of the cutting unit, mount the pivot
hub, the drive side groomer plate with quick-up lever
and the shim to the cutting unit side plate with (2) 3/8
x 1 inch socket head screws
Loctite to the screw threads prior to installation.
Important: Make sure the O-ring is properly
positioned on the pivot hub
(Figure
1. O-ring
Important: Make sure the splined end of pivot
hub shaft fits into the splined insert.
7
7). Apply blue Loctite to the threads of the
Figure 7
2. Clean out these holes
(Figure 9).
7).
(Figure
(Figure
Figure 8
9). Apply blue
8).