Toro 03713 Operator's Manual page 13

1. Groomer shaft assembly
2. Groomer plate w/quick-up lever (non-drive end)
3. Pivot hub (drive end)
4. Splined shaft
5. Groomer plate w/quick-up lever (drive end)
6. Quick-up lever
25. Secure the non-drive pivot hub to the cutting unit side
plate with (2) 3/8 x 1 inch screws
blue Loctite to the screw threads prior to installation.
26. Make sure the seal lip on each excluder seal, is in light
contact with each bearing housing
Figure 25
1. Excluder seal
27. Mount the quick-up lever assemblies to the side plates
with 3/8 x 3/4 inch flange head bolts
(Figure 24). Apply
(Figure 25).
2. Bearing housing
(Figure 24).
Figure 24
7. Shim (must remain loose after installation)
8. Pivot hub (non-drive end)
9. Idler spring
10. Belt
11. Seal spring
28. Install the groomer belt onto the pulleys
Make sure the ribs on the belt are properly seated in
the grooves on each pulley.
29. Hook the idler spring in the hole in the idler plate tab
and around the groove on the groomer plate lower stud
(Figure 26). The open end of the spring hook is to be
positioned toward the drive pulley.
13
(Figure 24).