Groomer Binding Troubleshooting - Toro 03713 Operator's Manual

Groomer Binding
Troubleshooting
1. Make sure the groomer is set to the desired height of
groom (HOG) (Figure
1. Quick-up lever (engaged
position)
2. Groomer height (HOG)
2. Loosen quick-up mounting bolt and make sure
threaded rod is in line and not binding on bottom
quick-up ramp (Figure
3. Check the length of the quick-up springs on the
threaded rods, the length should be 1-3/8 inch (3.5
cm) long (Figure 45).
1. Quick-up mounting bolt
4. If the height adjuster knob does not rotate freely, the
bushing may be dirty
if necessary.
44).
Figure 44
3. Height adjuster knob
4. Number of rear roller
spacers (below side plate
pad)
45). Re-tighten bolts.
Figure 45
2. Height adjuster knob
(Figure 45). Clean the bushing
5. If a roller brush is installed, make sure the brush plate
(Figure 46) is parallel to the cutting unit side plate and
is fully inserted into the rubber grommets.
G011430
1. Brush plate
6. Make sure the main drive bushing
freely around the drive hub.
1. Main drive bushing
7. Make sure the shim
groomer pivot plate and the cutting unit side plate is
not pinched by the pivot hub. Shim must be able to
move freely.
22
1
Figure 46
(Figure 47) pivots
Figure 47
(Figure 48) between the drive side