Toro 03713 Operator's Manual page 16

46. Push down on the idler pulley to ensure that the idler
pulley assembly pivots freely.
47. Check the alignment of the belt/pulleys as follows:
•
Lay a straight edge along the outer face of the drive
pulley (Figure 33).
G011428
Figure 33
•
The outer faces of the drive and driven pulleys
should be in line within .030 inch (.76 mm).
•
If the pulleys are not aligned, Refer to the section
on Pulley Alignment.
•
If the pulleys are aligned, continue with the
installation.
•
Do Not use the idler pulley to check alignment.
Important: The belt may fail prematurely if the
pulleys are not properly aligned.
48. Slide the belt cover onto the mounting bolts and secure
with (2) flange nuts
Important: Do not overtighten nuts as damage
to cover may occur.
Figure 34
1. Belt cover
49. Fill each reel bearing housing with grease
Excess grease will purge between the inboard seals and
the seal guards.
(Figure 34).
(Figure
50. Grease each of the groomer bearings (2 or 3 pumps
maximum)
grease may cause seal failure. Wipe off any excess
grease.
Note: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.
51. Adjust the height of the groomer. Refer to Adjusting
Groomer Height.
35).
16
Figure 35
(Figure 35). Do not over-grease as excess
G011429