Toro 03713 Operator's Manual page 9

20. Mount the quick-up lever assemblies to the side plates
with 3/8 x 3/4 inch flange head bolts
21. Install the groomer belt onto the pulleys
Make sure the ribs on the belt are properly seated in
the grooves on each pulley.
22. Hook the idler spring in the hole in the idler plate tab
and around the groove on the groomer plate lower stud
(Figure 11). The open end of the spring hook is to be
positioned toward the drive pulley.
Figure 11
1. Idler spring
2. Idler plate tab
23. Check the alignment of the belt/pulleys as follows:
•
Lay a straight edge along the outer face of the drive
pulley (Figure 12).
Important: Do Not use the idler pulley to
check alignment.
Figure 12
(Figure 9).
(Figure 9).
3. Lower stud
•
The outer faces of the drive and driven pulleys
should be in line within .030 inch (.76 mm).
•
If the pulleys are not aligned, refer to the section
on Pulley Alignment.
•
If the pulleys are aligned, continue with the
installation.
Important: The belt may fail prematurely if the
pulleys are not properly aligned.
24. Install the groomer cover and secure with (2) 5/16 inch
flange nuts (Figure
Important: Do not over tighten the nuts as
damage to the cover may occur.
1. Cover
25. Fill each reel bearing housing with grease
Excess grease will purge between the inboard seals and
the seal guards.
26. Grease each of the groomer bearings (2 or 3 pumps
maximum) (Figure
grease may cause seal failure. Wipe off any excess
grease.
9
13).
Figure 13
(Figure
14). Do not over-grease as excess
Figure 14
14).