Information Codes - Dacor DTI36M977BB User Manual

Information codes

Code
C0
C1
C2
F0
F1
F2
A2
UP
d0
NZ9500K_MOD_DTI36M977BB_DG68-00899A-02_EN+MES+CFR.indb 63
Possible cause
The top sensor is open.
The top sensor is short.
The IGBT sensor is open.
Communications between
the main and the sub PCBs
failed.
Communications with
EEPROM failed.
Communications with the
touch-enabled IC failed.
The fan motor
malfunctions.
The input voltage is too
high or low.
The key is pressed for
more than 8 seconds.
Solution
Turn the cooktop off, and then restart.
If the issue continues, unplug the power
cord for 30 seconds or more, and then
reconnect. If the issue is not resolved,
contact a Dacor service center.
Restart the cooktop using the POWER
button. If the issue continues, disconnect
power for more than 30 seconds. Then,
restart the cooktop. If the issue is not
resolved, contact a Dacor service center.
It occurs when the DC motor can not
operate due to defects of the PCB, wiring
or blockage on the motor blade.
Check the power connection and make
sure to turn the cooktop on after
regulating the voltage (208 V to 240 V).
Check if the key pad is wet or a key is
depressed. If the problem continues,
restart the appliance using the POWER
button. If the problem still continues,
contact a local Dacor service center.
English 63
2017-08-01 12:01:25