Troubleshooting; Operating Noises; Checkpoints - Dacor DTI36M977BB User Manual

Modernist induction cooktop
Hide thumbs Also See for DTI36M977BB:
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting

Operating noises

You may hear the following operational noises:
• Cracking noises: You may hear a cracking noise when you are using cookware made of
two or more materials.
• Whistling: A whistling noise occurs when both back burners are in use. This is caused
by vibrations. Whistling can vary depending on the weight or material of the cookware
or the type of food you are cooking. The noise can be reduced by using thicker
cookware.
• Humming: You may hear a low humming noise when you set a burner to a high power
setting. This sound is generated by energy transmission, and it will disappear when the
cooktop is turned off.
• Clicking: Electric switches are operating.
• Hissing, buzzing: You may hear a fan noise during cooktop operation. You may
continue to hear it even after the cooktop is turned off. This is normal. The fan runs to
cool down the temperature inside the cooktop. It will automatically shut itself off after
a short period of time.
These noises are normal and do not indicate any defects.

Checkpoints

If you encounter an issue to check with your cooktop, first check the table below and try
the suggestions.
Symptom
The burners heat
up slowly or
cannot maintain a
rolling boil.
The cooktop will
not turn on.
The burners do not
turn on.
60
English
NZ9500K_MOD_DTI36M977BB_DG68-00899A-02_EN+MES+CFR.indb 60
Possible cause
You may be using
incorrect cookware.
There is a blown fuse or
tripped circuit breaker.
The LCD is booting.
There is a blown fuse or
tripped circuit breaker.
The cooktop controls are
not set correctly.
Solution
Place the cookware in the center of the
cooking zone.
Use cookware with ferromagnetic
bottoms whose diameter is appropriate
for the cooking zone.
See the Cookware section on page 28.
Replace the fuse or reset the circuit
breaker.
It takes approximately 1 minute for the
LCD to boot.
Replace the fuse or reset the circuit
breaker.
Make sure the controls are set correctly
for the respective surface unit.
2017-08-01
12:01:24

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dti30m977bbDti36m977bb/da

Table of Contents