Comm. Config. Page; Control Page - Huawei UPS5000-S-300 kVA User Manual

UPS5000-S-300 kVA User Manual
(3P3W, 200 V)
Item
overtemp.
Table 4-17 Battery Setting
Item
Bat mode shut
Backup time
warning
Remain. cap.
warning
Thres. of low
batt. SOC over
dry contact (%)
Thres. of low
batt. volt. over
dry contact
(V/cell)

4.2.2.2 Comm. Config. Page

Open the Comm. Config. page to set communications information.
Figure 4-40 Comm. Config.

4.2.2.3 Control Page

Open the Control page to control the system running.
Issue 01 (2020-03-06)
Description
Description
In battery mode, the UPS can automatically
power off according to the preset shutdown
delay time. If the parameter is disabled, this
function is not available.
An alarm is generated if this parameter is set to
Enable and the backup time is less than the
warning threshold.
An alarm is generated if this parameter is set to
Enable and the remaining capacity is less than
the warning threshold.
If an output dry contact is set to Low battery
SOC, and the battery SOC is lower than this
threshold, the output dry contact will output
signals.
If an output dry contact is set to Batt. Volt.
Below Threshold, and the battery voltage is
lower than this threshold, the output dry contact
will output signals.
Copyright © Huawei Technologies Co., Ltd.
4 User Interface
Default Value
Value Range
Default Value
Value Range
Disable Disable,
Enable
Disable Disable,
Enable
Disable Disable,
Enable
70 5–80
1.70 1.70–2.10
112