Advertisement
Programming Notes
Enable/Disable User Codes:
When all User Codes are disabled, all electronic functions will be disabled as
well. The door must be locked or unlocked manually with the key. Repeat the
programming steps to enable the User Codes.
Add One-Time Use Code:
Up to 10 One-time User Codes can be saved. One-time User Codes should be 4 to
8 digits in length. The One-Time User Code will be deleted automatically after it is
used. The same One-Time User Code can be created again after it's used.
Change Auto-Lock Time Delay:
Press the keypad number that corresponds to your time delay preference:
"1": 30 seconds
"2": 1 minute
"3": 3 minutes
"4": 5 minutes
"5": 10 minutes
Enable/Disable AutoLock:
The default setting is disabled. Once you enable auto-lock the default setting is
set to 30 seconds.
To change the auto lock time delay, see the "Change Auto-Lock Time Delay"
programming step.
Repeat the programming steps to disable auto-lock.
Door Rehanding Identification:
Perform this process for the lock to learn the locking and unlocking direction of
the door.
This feature is used for the lock to learn the orientation of your door (left- or right-
handed). If stuck/jammed bolt error continues to occur after performing this
step, please make sure there is no obstruction from strike or door jamb to prevent
the bolt from extending.
Factory Reset:
A factory reset will delete all User Codes and change all programming to factory
settings.
21
Advertisement
Need help?
Do you have a question about the SMARTCODE and is the answer not in the manual?
Questions and answers
How many digits can be used to program? 4 or 6 or more
You can program the Kwikset SmartCode lock to have 4 to 8 digits.
This answer is automatically generated
how to enable the auto lock
To enable the auto lock feature on a Kwikset SmartCode lock, follow these steps:
1. Remove the Cover: Unscrew and remove the battery cover from the interior side of the lock.
2. Locate the Auto Lock Switch: Find the small switch or button labeled for auto lock inside the battery compartment.
3. Enable Auto Lock: Move the switch to the "on" position or follow the specific button sequence mentioned in the lock’s manual.
4. Replace the Cover: Secure the battery cover back in place.
5. Test the Feature: Lock and unlock the door to ensure the auto lock function is working.
This setting will automatically lock the door after a short delay when it is left unlocked.
This answer is automatically generated
We can’t program the code