62541 / 01
Required tools
Additional tools
(if needed)
wood block
1
Prepare door and check dimensions
If drilling a new door, use
the supplied template and
the complete door drilling
instructions
2
Disconnect knobs (if pre-assembled)
A
Do not remove
screws!
B
Twist the side
with the holes.
C
Set knobs aside until step 5.
3
Adjust the backset of the latch (if needed)
A
Hold the latch in front of the door hole, with
the latch face flush against the door edge.
B
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 4.
If the latch holes are NOT centered, adjust
latch. See "Latch Adjustment" (step 3C).
C
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
Drilling Template
Edge of the door
Do not use harsh chemicals or
solvents to clean your lock.
Mechanical lock
Use a damp cloth to wipe away
any excess dirt or debris.
Parts in the box
Latch
A
Not required for all applications
SmartKey® tool
(SmartKey locks only)
2-3/8" (60 mm)
2-3/4" (70 mm)
counter-clockwise
Template is only needed if a new hole must be drilled in the door.
Face of the door
Fold
Centerline
2-3/8" (60 mm)
2-3/4" (70 mm)
Backset
Electronic lock
Use a damp cloth on the lock's exterior to wipe
away any excess dirt or debris. Use a dry cloth to
clean interior components.
Screws
B
C
Keys
F
or
2-1/8"
54 mm
Instructions continue on reverse
Installation Guide
Strike
D
J
Knobs
G
1-3/8"–2-1/4"*
35 mm–57 mm*
1"
25 mm
*Call Kwikset to order
a service kit for 2-1/4"
(57 mm) thick doors.
Pull to
separate
knobs.
A
centered
not centered
E
H
Need help?
Do you have a question about the 62541/01 and is the answer not in the manual?
Questions and answers