Advertisement
Tighten the screws evenly.
DO NOT over-tighten.
TOP on the
mounting plate
should be visible
52367
(2X)
[INSIDE]
Route the cable
B
through the
center hole of the
mounting plate.
Keep parallel to
the door edge
Make sure the flat
blade is centered in the
mounting plate hole.
Push the cable into
C
the bottom hole of
the mounting plate.
Insert the key and test
D
the latch. If the latch
does not extend or
retract smoothly, adjust
the screws. Leave bolt
LOCKED/EXTENDED.
11
Advertisement
Need help?
Do you have a question about the SMARTCODE and is the answer not in the manual?
Questions and answers
How many digits can be used to program? 4 or 6 or more
You can program the Kwikset SmartCode lock to have 4 to 8 digits.
This answer is automatically generated
how to enable the auto lock
To enable the auto lock feature on a Kwikset SmartCode lock, follow these steps:
1. Remove the Cover: Unscrew and remove the battery cover from the interior side of the lock.
2. Locate the Auto Lock Switch: Find the small switch or button labeled for auto lock inside the battery compartment.
3. Enable Auto Lock: Move the switch to the "on" position or follow the specific button sequence mentioned in the lock’s manual.
4. Replace the Cover: Secure the battery cover back in place.
5. Test the Feature: Lock and unlock the door to ensure the auto lock function is working.
This setting will automatically lock the door after a short delay when it is left unlocked.
This answer is automatically generated
We can’t program the code