Temporary Operational Non-Permanent Changes (No Reboot Required); Figure 7-5 Set Minimum Remote Station Power - Siemens A53687 Installation & Operation Manual

OPERATION
_________________________________________________________________________________________________________
Tx iTrim :
Tx qTrim :
Doppler Feq Est :
Second LNA enable :
Current UL FEC Code:
Current DL FEC Code:
Power Control Mode:
For a full description of the CLI commands, refer to the Mercury Command Line Interface (CLI)
Manual.

7.2.3 Temporary Operational Non-Permanent Changes (No Reboot Required)

This section describes the recommended techniques for managing temporary non-permanent
configuration changes in an experimental test environment.
CLI commands can be used to change certain parameters for test purposes. These changes
are not permanent and are undone whenever the system is rebooted. Any changes to the
configuration files that are intended to be permanent need to be made by editing the
configuration files directly in WinSCP or through Apollo.
The following parameters can be changed temporarily:
1. Change the maximum and minimum transmit power for Mercury.
Set Minimum Remote Station transmit power type as shown in Figure 7-5. The
Minimum transmit power range is 0 to 25 dBm
Set Minimum Remote Station transmit power type as shown in Figure 7-6. The
Maximum transmit power range is 0 to 25 dBm.
COM-00-21-03
Version No.: A
:
-35
:
-87
:
0
:
1
:
5
:
5
: Hybrid power control
mode

Figure 7-5 Set Minimum Remote Station Power

Up-link DC offset real
Up-link DC offset imag
Doppler frequency offset
Second LNA Parameter
Uplink modulation
Downlink modulation
Uplink Power control mode
7-4
OCTOBER 2021