Table of Contents
Advertisement
_________________________________________________________________________________________________________
These are the CLI commands available for the RS. If the command "show ms measurement
report" is typed, then the measurement report is shown in Figure 7-4
Mean DL CINR :
Mean DL CINR Min :
Mean DL CINR Max:
Rx Gain:
DL-FreqErr:
UL-FreqErr:
DL Preamble RSSI :
Mean DL RSSI :
DL RPD :
DL Path loss :
MS Tx Power :
DC Offset Real :
DC Offset Imag :
Avg DC Offset Real :
Avg DC Offset Imag :
COM-00-21-03
Version No.: A
Figure 7-4 MS Measurement Report
:
27 (dB)
:
13 (dB)
:
34 (dB)
:
10 (dB)
:
-135 (Hz)
:
0 (dB)
:
-73 (dBm)
:
-73 (dBm)
:
-63 (dBm)
:
109 (dB)
:
21 (dBm)
:
0 (mV)
:
0 (mV)
:
-1113
:
-1443
7-3
Average DL CINR
Minimum CINR
Maximum CINR
RX Gain configured
Down-link frequency error
Up-link frequency error
Down-link preamble RSSI of current frame
Average preamble RSSI
Down-link Receive Power Density
Down-link path loss
Up-link power configured
Down-link Hardware DC offset real in mv
Down-link Hardware DC offset imag in mv
Down-link software DC offset real
Down-link Hardware DC offset imag
OPERATION
OCTOBER 2021
Advertisement
Table of Contents
