Table of Contents
Advertisement
CONFIGURATION
_________________________________________________________________________________________________________
This section describes the key configuration elements for the Mercury Remote station on a per
file basis. Be aware the configuration files contain many other parameters which should not be
modified
●
start_mercury.sh – This is the file the remote station uses when it's initially turned
on. This will be custom tailored by Siemens based on each customer's
requirements. Changes should be coordinated with Siemens.
●
ms_config.xml – This is the configuration file for the RS. This can be a single file or
a symbolic link file (pointer file) that points to the file that contains the configuration
information for the remote station. It contains the IP configuration, system
information which includes the channel bandwidth, the RF information which
includes TX/RX frequency, and many other configuration parameters. These
configuration parameters, their definitions, and possible values can be found in the
"Airlink Mercury Parameter Configuration Manual" for your software version. As a
note, many parameters in this file are interrelated and should not be changed
without advanced knowledge of the system. Parameters that can be changed are
listed below:
○
IP CONFIGURATION (IP address, Netmask, Gateway, etc.)
○
UL/DL Frequency
○
RX_Gain
○
Sub-channel bitmap
●
snmpd.conf – SNMP configuration information
COM-00-21-03
Version No.: A
WITHIN THE ROOT DIRECTORY OF THE RS, THERE ARE SEVERAL
IMPORTANT FILES. IT IS IMPORTANT TO BE CAREFUL WHEN MAKING
CHANGES TO THE DIRECTORY. CHANGES TO THESE IMPORTANT
FILES CAN CAUSE THE RADIOS TO NOT CONNECT. PLEASE
PROCEED WITH CAUTION.
CAUTION
6-8
OCTOBER 2021
Advertisement
Table of Contents
