Mandatory Product Labels; Figure 4-4 Mandatory Product Labels; Table 4-1 Connection Summary - Siemens A53687 Installation & Operation Manual

GPS SYNCHRONIZATION
_________________________________________________________________________________________________________
Connection/Switch
Ground Post
Input - / +
LED Power Indicator
GPS
RF
Serial
(+Console)
Eth
4.5

Mandatory Product Labels

Mandatory product labels can be found on the rear of the unit as shown in Figure 4-4.
COM-00-21-03
Version No.: A

Table 4-1 Connection Summary

Connection to protective earth ground. Use a #10-32 thread locking nut
torque to 8 inch-pounds with a 3/8" wrench.
The Radio is supplied with a mating screw terminal plug, Phoenix P/N: 1777989,
that needs to be wired.
DC power input 12 to 24 VDC (12 - 13.3 VDC nominal), 2A maximum. Tighten
screw terminal locking screws using a screwdriver to prevent disconnection of
plug from the socket.
Ensure correct polarity when wiring DC power supply to screw terminal
plug. Power supply (not provided) must meet electrical requirements and
State and local code requirements for use application. Installation by
qualified personnel only.
LED power indicator indicates the power and the connection status.
SMA female connector torqued down to 5 inch-pounds with 5/16" open-end
wrench for an optional GPS antenna.
SMA female connector for RF input/output from the antenna. Torque hex
connector to 15 inch-pounds with 5/8" open-end wrench.
Never energize the Mercury radio without a 50 Ohm (4 Watt min) load (or
antenna) on the RF connector.
RJ45 8-pin socket wired using the Cisco interface specification for RS232 serial
data. The embedded Console interface is provided by the adapter cable
described.
RJ45 8-pin socket for CAT5/6e Ethernet 10/100 Base-T cable interface.

Figure 4-4 Mandatory Product Labels

4-4
Application
OCTOBER 2021