Powering On The Phone - Cisco 7920 Phone Manual

Powering On the Phone

To power on the phone, press and hold the
(green) key until the phone powers on. The phone
goes through the following startup process:
1. The phone connects to a wireless access point and
begins authentication.
You might need to use a username and password
to access the wireless network. See the "Setting
Passwords" section on page 23.
2. After completing authentication, the phone
displays the main screen, as shown in Figure 2-2.
The phone is in standby mode and is ready to
place or receive calls.
3. The signal icon in the upper, right corner shows
the strength of the signal between the wireless
access point and your phone. Your phone must
have an adequate signal before you can place or
receive calls.
The icon displays six vertical bars for a strong
signal. The icon displays fewer than three bars to
indicate that the signal is weak.
Tip
When the phone receives a weak signal, the phone
displays this warning message, "Weak signal
detected" and sends a tone or vibration as specified in
your active profile. See the "Configuring User
Profiles" section on page 69 for more information.
18 78-16888-01