Microgate Racetime 2 User Manual page 4

Racetime 2 - OptoJump Program
A : Single start
B : Group start
C : Simple stopwatch
A B
F1 F2 F3
A : Parallel mode
B : PC ON-LINE mode
C : OptoJump
A B
F2
F1
Clear all config. data?
Yes
F1 F2
Should you have canceled the memorized data, if your
Racetime 2 chronometer is equipped with other timing
programs (in addition to the Optojump management
program), you can select the function mode.
C more
To select the Optojump program, first press F4 (other) to pass
to the second screen display.
F4
Now press F3 (C: Optojump) to enter Optojump mode.
These operations are not necessary if your Racetime 2 is
C menu
equipped with only the Optojump program.
F3 F4
If the data memory has not been canceled or the Optojump
mode was chosen in the previous work session, you can set
configuration parameters automatically on standard values,
namely:
No
• Automatic printout on confirmation of test: deactivated
• Average value calculation mode: on all values
• Number of WalkJump modules: 6
F3 F4
• WalkJump start mode: manual
• WalkJump timeout: 0s (deactivated)
• WalkJump step minimum length: 41cm
• WalkJump direction: entrance from interface side
• WalkJump automatic acquisition: deactivated
• OptoJump test start: from inside measurement base
The meaning of each parameter will be clear when you have
become familiar with the different types of test, which are
described in the following pages.
User manual 4