Microgate Racetime 2 User Manual page 11

Racetime 2 - OptoJump Program
Start: extern
Int Ext
F1 F2
Start: extern
Num. Of jumps:
F1 F2
Athlete 1
Test N. 1
Start from inside
OK Edit Setup menu
F1 F2
To confirm the settings and to go on to the performance of the
test, press F1.
See the following paragraph for an explanation of the values
displayed during the test.
5.2
F2 – Jump test jumps
Select this mode to perform tests with a pre-established
number of jumps.
After selecting the test, select the start mode (i.e. the position
OK
of the athlete at the start of the test) with the keys F1 (test start
from inside the measurement area) or F2 (test start from
outside the measurement area).
F3 F4
Press F4 (OK) to confirm your choice.
Insert the number of jumps you wish to make.
#
F3 F4
5.3
Racetime 2 will then show the athlete's code and test.
(Important: the combination athlete's code/test number is a
single item, i.e. Racetime 2 does not allow the same athlete to
perform two tests indicated by the same test number).
Choose F1 (OK) to confirm the setting and to begin the test.
By pressing F2 (Edit.) you can correct the number of the
athlete and/or test.
F3 F4
F3 (Impos) will return you to the setting of the start test mode
and of the number of jumps.
To return to the 'New tests' menu, press F4 (menu).
User manual 11